F3 RacerCube with 10A 4 in 1 ESC

Specifications:

RacerCube

Weight: Approx 7.8g

Omnibus F3

With MPU6000 (6DOF Version)
IC STM32F3CCT6 with 256K
Onboard 5V/1A BEC (Output)
Onboard OSD
Weight: 8g
Size: 27x27mm
Mounting: 20x20mm (M2.5)
Onboard LC Filter
Support Cleanflight & BetaFlight
Input Voltage: 2-4S Li-Po
Support SBUS/PPM/DSMX
Support Buzzer / Programing LED

Set RX3 as connection port when SBUS/DSM is used
DMS uses 3.3V
SBUS/PPM uses 5V

BLHELI_S 10A ESC

Firmware: BLHELI_S
Voltage Input: 2-4S LiPo/2-4S HV LiPo
BEC: None
Current: 10A (15A Peak @ 5 seconds)
Size: 27x27mm
31*3.15mm Included Soldering Pads
Mounting: 20x20mm (M2.5 Hole)

Weight: 3.6g
DSHOT, OneShot Supported
MOS: TPN2R703NL
MCU: SILABS  EFM8BB21F16G

Package Included

1 x F3 Omnibus Fight Controller

1 x 10A 4-in-1 ESC

Note: M2 Nylon Spacers are used on these boards. So you may need to get some M2 size spacers and screws.

** Warning: The default firmware shipped with the board has been tested and configured by the factory in working condition (factory flashed the board with tested firmware manually via USB). You will be responsible for damage (or any part of function not working) if you flash your own firmware. So you are recommended to use the default firmware which has been shipped with the board.

** Warning: You must be very be careful when soldering this ESC because of it’s very small size.

Full wiring diagram can be found in the download section of this website.